Adam carom top ends

Are you looking for an Adam carom shaft for your billiard cue? At Van den Broek Biljarts, we help you choose a suitable model. A new shaft is a practical solution when your current one needs replacing. It is also a handy addition as a spare shaft during training and matches.

A new tip for your Adam carom cue

With a suitable new top end, you can continue using the familiar butt section of your Adam cue. Choose a version that matches your playing preference and always check that the connection is suitable for your cue.

An extra tip also offers the possibility to play with a different tip or diameter, without immediately purchasing a completely new cue.

Which Adam tip fits your cue?

When choosing an Adam carom cue shaft, pay attention to the connection, length, and tip diameter. Do not automatically assume that every shaft fits every Adam butt. Check the product specifications or ask us for advice.

Important factors in your choice are:

• The connection between the top end and the bottom section.

• The material and the workmanship.

• The length of the top end.

• The diameter of the French kiss.

• The type of Cucumber and the hardness.

Pomeranian and play feel

The cue tip influences contact with the cue ball and the feel during the shot. Would you like to keep your trusted tip or try a different version? We are happy to help you decide.

Check for each product which cue tip is fitted as standard and which options are available.

Buy Adam carom billiard tips at Van den Broek Biljarts

Van den Broek Biljarts has over 60 years of experience with billiards, cues, and maintenance. You can come to us for advice on Adam carom cue tips, cue repair, and replacing tips.

Unsure which tip is suitable? Contact us or visit our store in Almere. Bring your cue with you so we can assess the connection.

Important information regarding the purchase of an extra top end / shaft

When purchasing an extra shaft , it is important to pay close attention to the wooden screw joint . Even if you buy a shaft from the same brand as your cue, that does not automatically mean it will fit perfectly . Wooden joints are made individually and can always vary slightly in size or fit.

Be careful when tightening

Is the top end screwing too tightly into the bottom end? Then never overtighten. Forcing it can damage or even break the threads , resulting in permanent damage.

Possible solutions

There are a few safe ways to improve an overly tight wooden fit yourself:

• Sprinkle talcum powder lightly on the screw thread and try again.

• Apply graphite (with a regular pencil) to the screw thread

• Very fine sandpaper (use only very carefully and exclusively on the wooden part)

These methods can sometimes make the fit just smooth enough without causing damage.

Never use wet or greasy lubricants

Never use soap, wax, oil, grease, or other wet lubricants . You might be able to assemble the cue with these, but often won't be able to take it apart again — with a high risk of permanent damage.

Is it still not working?

If talcum powder, graphite, or fine sandpaper still doesn't work , send the entire cue to us. We can make the fit professional and secure.

Call us: 0365374054 Email us: [email protected]

We are happy to help you so that your cue aligns perfectly again.